3 pack reverse osmosis filters Maxi

Pack of 3 Filters for Reverse Osmosis Maxi 200 and 400 GPD

Pack of 3 filters for Maxi 200 GPD and Maxi 400 GPD semi-industrial reverse osmosis.

This pack includes:

• 1 Polypropylene filter cartridge 5 microns:

            - Height 20 "

            - Maximum flow 1.6 m3 / h

            - Reference FS1003

            - Measures 510 mm long x 62 mm diameter x 27mm inner diameter

            - Polypropylene filter to remove sand, dirt and rust particles

            - Only for use with water

            - Maximum water temperature 52ºC

            - CAUTION!

For potable water applications, do not use where the water is not microbiologically safe or with water of unknown quality without adequate disinfection before or after the unit. This cartridge will not remove chemicals or disinfect water.

            - The cartridges can be used as a final filter or as a pre-filter, as long as the most expensive filtration systems such as absolute micro-filtration are to be safeguarded. The cartridges have been tested to obtain a filtration of at least 95% of the suspended particles.

            - The extraordinary filter capacity of the cartridges is obtained thanks to a large surface of filter material. The cartridges must be replaced when the loss of charge begins to be observed; in any case, the substitution will be subject to the maximum level allowed and / or required by the process in progress.

• 1 filter 20 " in-line granulated activated carbon filter:

            - Height 20 "

            - Maximum temperature: 37.7 ºC.

            - Minimum temperature: 4.4 ºC.

            - Useful life / production: 8000 liters or 1 year.

            - Maximum pressure: 5 bar.

            - Reference FC1003

            - This filter removes elements such as chlorine, particles and other organic components that contribute to the bad taste and odor of the water.

            - Attention: Do not use the filter where the water is microbiologically unsafe or of unknown quality.

• 1 Active carbon filter block 20 ":

            - Height 20 "

            - Maximum temperature 37.7 ºC

            - Minimum temperature 4.4 ºC

            - Useful life / production 8000 liters or 1 year

            - Maximum pressure 5 Bar.

            - Reference FC2002

            - This filter removes elements such as chlorine, particles and other organic components that contribute to the bad taste and odor of the water.

            - Warning: do not use the filter where the water is microbiologically unsafe or of unknown quality.

INSTRUCTIONS:

1. Close the water inlet before changing the cartridge.
   
2. Pay attention to the direction of the water flow in the filter.
3. Connect the filter to the line and turn on the water supply.
4. Check for leaks.
5. Clean or purge the carbon from the filter into a bucket through the filter outlet until clear water comes out.

Replacement kit for original filters for semi-industrial reverse osmosis Maxi 200 GPD and Maxi 400 GPD.